Digital Circuits Part 2

The purpose of the integrator and gate circuits is to pass on the number of pulses that match the test voltage being measured. Since a specific pulse frequency stream is being applied to the gate, the test voltage must somehow control how long the gate will be allowed to pass the pulses; the higher the test voltage, the longer the gate will be open, and the more pulses will be passed through- and the number of pulses will represent the digitized version of the analog test voltage.

Continue reading “Digital Circuits Part 2”

Digital Circuits

Input Networks and Amplifiers

The input network and amplifier perform the same functions as they do for the electronic analog meter. The input network presents a high resistance (11 megohms) to the circuit under test to keep from loading it down; it also attenuates the input voltage with the range switch setting to keep the test signal at the input of the amplifier under 1 volt. Although identical input and amplifier circuits can be used for both digital and analog meters, the example we are using demonstrates the use of an amplifier that can take up to 1 volt of input, and the ranges vary from 2 volts to 2000 volts, in multiplier ranges of 2, 20, 200, and 2000 volts. Since digital measurements use ten digits (0- 9), the counters, and especially the pulse generators deal in multiples of ten for convenience. The follower and amplifier circuits are both op-amps connected to accomplish their functions.

Continue reading “Digital Circuits”