PCI-6052 Request for Availability

National Instruments PCI-6052 Multifunction I/O Device

The NI PCI-6052 Multifunction I/O Device has 16 analog input channels, 333 kS/s sample rate for every channel, and 16-bit resolution. This device has an on-load up checking interim; the counter uses the SISOURCE motion as a timer to synchronize the age of the STARTSCAN signal. It is possible to arrange the PFI stick selected as the hotspot for the SISOURCE motion in the level identification mode. The user can set the extremity choice for the PFI stick for dynamic high or dynamic low.

Any PFI stick can remotely enter the AIGATE signal, which is not accessible as an output on the I/O connector. The AIGATE signal can cover checks in a DAQ arrangement. In the level location mode, if AIGATE is dynamic, the STARTSCAN signal is veiled and sweeps cannot be performed. In the edge discovery mode, the principal dynamic edge deactivates the STARTSCAN signal and the second dynamic edge STARTSCAN starts.

On the National Instruments PCI-6052, the AIGATE signal cannot stop an output in advance or proceed with an examined already hindered. Essentially, once a sweep has begun, the AIGATE signal does not close the transformations until the start of the following output. Conversely, if the changes are dropped, the AIGATE does not square them again until the start of the following sweep. It is also important to highlight that the most extreme permitted frequency is 20 MHz, with a base heartbeat width of 23 ns high or low. In addition to what was previously mentioned, there is no base frequency impediment.

PCI-6052 End of Life Status has been announced by National Instruments, but will still be available for purchase and repairs by Apex Waves.